idioma ingles idioma español idioma frances

Battery Chargers


  • IP65/67

    BATTERY CHARGERS BLUEPOWER IP65/67

    The BluePower Battery Chargers feature a microprocessor controlled “adaptive” technology which controls the charge of the battery. The “adaptive” features will automatically optimise the charging process based on the battery duty cycle.

    This charger is ideal for it use in Marine Aids to Navigation installations as a power supply complement. Completely encapsulated in resin, thus providing a high resistance under harsh humidity and salinity conditions.

    Adaptive 3- or 4-stage charge characteristic, depending on model.

    Download PDF
    • Waterproof, ignition protected and shockproof:
    • Water, hydrocarbons or dirt will not damage the charger.
    • The enclosure is made from cast aluminium and the electronics are moulded in resin.
    • Protected against overheating:
    • Can be used in hot environment such as machine room, battery boxes or maritime towers..
    • Output current will be reduced when temperature increases (up to 60°C), but the charger will not fail..
    • 92% efficiency or better. Once the battery is fully charged, power consumption reduces to less than 1 Watt.
    • Adaptive 4-stage charge: bulk - absorption - float - storage. The “adaptive” feature will automatically optimise the charging process based on the battery duty cycle (12/7 model, 3-stage charge).
    • Two LEDs for status indication:
    • LED yellow: bulk charge.
    • LED green: float mode, battery charged.
    • LED yellow and green: absorption charge.
    • The “storage” mode prevents stratification of the electrolyte and sulphation, major cause of early battery failure.
  • PHOENIX

    BATTERY CHARGERS PHOENIX

    The Phoenix Battery Chargers feature a microprocessor controlled ‘adaptive’ battery management system that can be preset to suit different types of batteries. The ‘adaptive’ feature will automatically optimise the process based on the battery duty cycle.

    Adaptive 4-stage charge system: bulk – absorption – float – storage. Three outputs, two complete and one of 4 amps.

    Universal 90-265V input, 45-65 Hz.

    Download PDF
    • Adaptive 4-stage charge: bulk - absorption - float - storage.
    • The right amount of charge: variable absorption time. To prevent overcharging of the battery, the absorption time is kept short when only shallow discharges occur. After a deep discharge the absorption time is automatically increased to make sure that the battery is completely recharged.
    • Every charger comes with a battery temperature sensor. When connected, charge voltage will automatically decrease while increasing battery temperature. This feature is especially recommended for gelled batteries and/or when important fluctuations of battery temperature are expected.
    • Battery voltage sense, so that the battery always receives the correct charge voltage. This feature allows to compensate voltage losses due to cable resistance.
    • Universal input voltage range: 90-265V a.c. and also suitable for d.c. supply.
    • The “storage” mode prevents stratification of the electrolyte and sulphation, major cause of early battery failure.
    • Ready to communicate with a PC through its RS-485 serial port (wire not included).

Products: IP65/67, PHOENIX